Does this sound like something usable to fix my issue? Was the Peugeot engine a piece of junk? I dont see how Cat put this in a VC40 and then put it in a VC60 weighting 10,100 lbs. I cannot figure out if the hydro pump is dragging the engine down, or the engine is just flat wore out and not making any power under a heavy load factor. The engine is smoking from the PCV alot when it is straining under this heavy load. It is not stuck or anything, just cannot move based on the dirt pushing up in front of the tires. With the tires slowly sinking in the ground, it creates enough drag that the forklift will hardly move. As to the real issue, it is moving the thing on soft dirt. Then after about 10 minutes it starts to whine. It is quiet as a mouse when you are on a cold start. I have not tried anything heavier than this. The forklift will move somewhat ok on concrete flat surface. What I want to get is recommendations on what is wore out based on these symptoms. I have purchased a 1992 Cat VC60D with the Peugeot 4 cylinder engine.
0 kommentar(er)
